Date
1 - 5 of 5
[UBC-125XLT]
|
Jay Law <jaylaw99@...>
Ref - Custom search ranges...
There are 10 pre-programmed search ranges, all of which can be customised to search a specific range of frequencies (through program limits). Is there a way of 'resetting' custom search ranges to the default values? This is to avoid having to memorise the search ranges.... I have spent hours trawling the manual and YT looking for solutions.. Thanks. Jay
|
|
|
|
Joe M.
You can 'reset' them to be whatever you
toggle quoted messageShow quoted text
want or whatever you can easily remember. Joe M.
On 5/18/2020 12:31 PM, Jay Law wrote:
Ref - Custom search ranges...
|
|
|
|
Jay Law <jaylaw99@...>
Thanks Joe
They can't be programmed to whatever I want because the frequencies have to be within the range of the Bank...otherwise you get an 'out of band' error. I take it the solution is to carry this ⇓ around or memorise the frequencies... 
|
|
|
|
Joe M.
True, you cannot search across bands. I didn't think that needed said.
toggle quoted messageShow quoted text
You can just activate a range. If it's lower (higher) than the one you want, just deactivate it and activate the next higher (or lower) one. Joe M.
On 5/18/2020 1:38 PM, Jay Law wrote:
Thanks Joe
|
|
|
|
Joe M.
If it were me, I would make row 1 Low
toggle quoted messageShow quoted text
Band, Row 2 VHF, Row 3 UHF, and 10 800. Easier to remember. Joe M.
On 5/18/2020 1:44 PM, Joe M. wrote:
True, you cannot search across bands. I didn't think that needed said.
|
|
|