A question to the multi-coupler supplier would be do all ports present a 50-ohm input/output? The Uniden could be more sensitive to an unbalanced load. Don W. KD4APP

Put the aerial feed direct to the scanner

Greetings, I have a Dell laptop with Windows 10 that decided it doesn’t want to run Windows 10 anymore and won’t download Windows 11. Are any of you running Windows 11 with Sentinel? If so,I’ll

On Friday, December 10, 2021, 07:29:20 AM MST, main@Uniden.groups.io <digestnoreply@groups.io> wrote: Did you try the Uniden by itself without the splitter to see if

This mulicoupler, is it buffered by each having an built in attenuator? If not it could be an input impeadance/loading issue. Try the discone direct to the radio first, then comeback. Mike

It is a new Stridsberg active multicoupler that is described as providing the same unattenuated signal to each of 8 BNC outputs, so i doubt that changing ports will have an effect. But, no harm in

Les, Have you tried swapping multicoupler ports?

Sorry for confusion - the Uniden misses what the ICOMs hear. Les

This venerable analog-only model is still being offered new, and I recently purchased NIB from reputable electronics retailer. Primarily for civil/mil airbands. My attic discone feeds the 15X and 3

Does the scanner properly receive any other programmed P25 trunking systems, simulcast sites or otherwise? Did you park the scanner on one of the frequencies in the system (not a control channel) to

*Hi Tim,** ** **I was going to recommend ProScan - that is what I use. I saw in your other post that you circled Mute. I would set it to OFF and see what happens.** ** **Also as someone else

Sentinel doesn't work on a bc796D but i have tried that using both uniden & proscan software

Turn the scanner on Press mute to unmute if needed READ from the scanner into Sentinel OVERWRITING your existing file/s. Put that into your other scanner and test. The mute on

Try turning the mute off, then read the scanner, then write back and see what happens. It could be a part of the RAM in the scanner going bad. That unit is only what? 20 years old? Joe M.

It looks to be pointing to the software, look it over real good and find what's holding the mute mode on.

Hi Don, I have the original uniden software and proscan software. I have done a factory reset (2,9,Hold Power on) and then tried to upload the program from uniden software and after i turn off the

Check your volume offset and attenuator setting.

Dennis said: No. He said he can hear the traffic on other scanners. 73 ----- Jim Walls - K6CCC jim@...

Sounds like it's encrypted, which some trunking systems have done... d.m.f. Nov 17, 2021 7:20:41 AM Eric Harjula <mainefire07@...>:

I recently got a new BCD536HP. I programmed it via Sentinel with my Favorites list and I am not getting anything on my states System(MSCommNet). I tried resetting the user settings, the full database