Date
1 - 2 of 2
The so called noise or hum depressor. SDS200 Noise Mitigation with Factory Part
|
Mark Bradley <whyme505898@...>
Question.....I saw the video on replacing the little square tin with copper on it.OK,the video showed the person putting the SDS200 Noise Suppressor Piece,he put it on with the TIN side up. OK,I took my scanner apart to see if it had it in there,and yes it did. But one problem,,,,this is put in with the COPPER side up.OK,which way does it go?????????I see it was done on mine,and also no scraping of the foam or rubber seal with the Uniden Buzz Be Gone Fix. I ordered one of those Buzz Be Gone Eliminator Fix Parts,I was going to put it 3 inches over from the other side for double BUZZ be gone fix,I will put it with the Copper side up,like the other side.I am curious if any one knows the CORRECT WAY to install the Metal,Copper tab.Thank you for your time,I appreciate this as I am wanting to know,the correct way. Have a great evening,,,Mark
|
|
|
|
Joe M.
It may not matter, as it is the same thickness either way. If I was pushed into an answer, I would say the one the factory installed is correct. But again, it may not matter.
toggle quoted messageShow quoted text
Do both units you have eliminate the vibration? Joe M.
On 1/27/2020 6:28 PM, Mark Bradley wrote:
Question.....I saw the video on replacing the little square tin with
|
|
|