Maybe I should not share this due to great embarrassment but. . . After many l weeks of not receiving the Onondaga County interoperability P-25 frequencies, thinking the P-25 board was burnt, the

Sounds great. Have a wonderful week. Butch, KE7FEL/r

Thanks Butch worked after attempting again.... <hotlrv1@...>wrote: -- APRS INFO N9MXT-10 I-GATE/DIGI N9MXT-9 MOBILE N9MXT BASE N9MXT-6 SATELLITE ISS 73 de N9MXT

I use the Butel software for my programming needs. Mine works wonderful. Did you try copying it to a CD, then using your cd to load it to the computer? Good Luck. Butch Kanvick [Non-text portions

Jeffery I just went to the butel.nl page and was able to pull up the 250 software download page. It shows up under the option for BC785/796 Try a refresh or history/coolies clear on your browser and

Hello, Need some software for this BC796D I have in the mobile. I used to use the BC250 years ago and the computer took a dump years ago also. Well, decided to once again reprogram any changes I

Thanks! -- Rich Osman, N1OZ mailto:n1oz@... Rich Osman; POB 93167; Southlake, TX 76092 (Near DFW Airport)

http://info.uniden.com/UnidenMan4/BC296DFirmwareUpdate UPMan From: Rich <n1oz@...> [Non-text portions of this message have been removed]

YOU PROBABLY NEED TO ADJUST THE SOUND QUALITY AS IT SAYS IN THE MANUAL.IT WILL CLEAN IT RIGHT UP.ANY QUESTIONS EMAIL klimp21@... <a href="http://www.myspace.com/klimp21" target="_blank"><img

Where do you get the rebanding and DSP update firmware? I don't see it on Uniden's site.

Go to the Uniden 296D site where you found the upgrades to the firmware. Quoting Jim Adams <blastdad51@...>:

how do I upgrade the card,I know my firmware is up to date?

Make sure that you have done all the updates to both the scanner and the digital card (2 seperate programs). Beyond that the type of digital system (single TX location C4FM vs multiple simulcast TX

Does anyone know if there is a way to check the APCO card in my BC296d. I'm wondering if my card is bad, the sound on all digital is miserable. I mostly listen to Santee Sheriff and Heartland Fire.

hello i am ready to send my 796d into uniden but i throught i'd ask this question b4 i do, i have had to use a premap via rf threw my car radio to be able to hear it. i replace the audio module but

selling my scanner with original box and cable with software very good condition $200 OBO

Jerry, You were the other 296 owner that I was thinking about in my first e-mail. I know that your home QTH seemed to be particularly bad for simalcast interference especially with the 296. Do you

Rod As you recall, I had the same problem with my BC296D. When you suggested I change the settings to "FM" I was finally able to use the scanner,although still had problems with the Cincy &

That's why I have to believe that it is in part based on the system settings. Joe M. Rod wrote:

It has been a while since I programmed a 296 and usually I used software to do it. For some reason, I remembered that it defaulted to NFM when I programmed a 800 MHZ trunked system. At any rate, FM